Steelman 10-In-1 Multi-Tip Folding Magnetic Pocket Screwdriver with Carrying Clip and Bottle Opener, Includes 3/16" and 1/4" Slotted, PH1, PH2, T15, T20, S1 and S2 Bits

One of the best tool I ever bought.

bought one of these and the magnets came loose one day, and then all of them eventually. emailed per diections on their website and got a brand new one and the magnets are all good months later.

This is a sweet concept and works great. I keep it in my truck and another in my backpack. As others have stated, the magnet for the extension is weak as hell and doesn’t hold the extension. It’s constantly falling off. Tempted to glue it in at this point or try adding a stronger one. That’s my only complaint. Otherwise it’s one of my favorites

seems like a good edc tool but could easily have been better. extention piece is the main issue. the body is square which can hang up in tight spots. the connection to the main tool is just a hex shaft into holding onto a weak magnet. will likely fall off if kept in the outside of a bag or belt. would have been considerably better if it could lock into an impact driver and have a detent retention to prevent falling out of the main body. opposite side that hold the bits is too tight, likely due to over paint, needed pliers to remove the bits from the tip. bits were not the ones that were advertised but I'll replace with higher quality bits so it was a non issue. Will either replace win round apex bit holder or glue it in place to just act as a cover so the bits don't fall out.overall a disappointment but i think i had too high of expectations. Will work for now.

I like that you can put the replacement bits in it. Customizable all in one screwdriver

Works as should

Love it. I didn’t like the bits it came with so I put Milwaukee bits in it.

This is a great basic concept, let down by some poor design choices and a lack of quality workmanship. The main flaw, and the one that basically ruins the tool, is that it can't hold onto its bits. The magnet in the driver is just extremely weak, and bits/extensions sit pretty loosely inside of it. This means that they just don't stay in, rendering it pretty useless as a screwdriver. I know it's only $25, but if you're not going to get that part right, why even bother?It's also a lot bulkier than it needs to be. The body doesn't need to be so chunky—the thick plastic scales serve no real purpose, the driver doesn't need to be a heavy square lump, and it would be easy to redesign the whole unit to be about 3/4" shorter. For an EDC-oriented tool, that's annoying. I've got full-featured, hunka-chunka multitools that are slimmer in the pocket than this. It's big enough to make me not want to keep it on me.So close to being a great tool. It would have taken so little effort to make a slimmer, higher-quality version of this exact same design, and I doubt it would even need to be more expensive. It's like they had a good idea, but then the people they gave it to to turn it into a product just didn't really care.