Lawn Garden / Go Kart Inner Tubes for 15 x 600 x 6

The tube works perfectly 5the only problem is the valve stem points directly to the edge of the rim so it makes putting air into it a little difficult but once it is aired up it holds air and works fine. Just wished the picture of the tube would show the stem better so I could have ordered a straight stem.

I knew that replacing the front tires on my John Deere riding mower would be difficult since the tires are small and fit very tight. I purchased this inner tube so I could put it in the tires before I installed them on the rims. After a few days stretching out the tires by inflating the tube inside the tire, the installation of the tire on the rim was made much easier.

The picture is very poor and you can't tell if it's the rubber stem or the metal one, or if the stem is perpendicular to the tube or parallel to it. I took a chance, using the posted description (90 degree/TR87) and it was what I wanted - 90 degree, metal stem, TR87. It's Oregon brand, supposedly made by Cheng Shin from the description. Time will tell how it holds up.

It was my mistake. The tubes do fit, but the bent tube valve stem would work better on a rim with the hole being more towards the center of the rim. These tubes work, but the stems lay right down on the rim. Like I said, should've bought the straight stem tubes. Otherwise, they are doing the job they were meant to do!

I bought this thinking it would be fun this summer to float the river with. It seems to be too small for that purpose though and will have to use it in my lawn mower instead. I think it is perfect for that.What can I say... small, round, black... holds air.... it is an inner tube.

When the tubeless tire came off my mower wheel a friend suggested using a tube inside and I thought it was a good idea. I was a bit hesitant to cut the stem out from the tubeless tire, but I did it, slipped this tube into the tire and blew it up. Yes! Tire is no longer flat and I have more confidence that on my very uneven terrain the tire will be far less apt to come off the wheel.

This was purchased to solve a leak on a lawn tractor's front tire due to a circumferencial crack in the (old) tire's mold joint which could not be patched conventionally for a tubeless tire. The tube did the job. It seems to be well made. The stem is a 90 degree made of brass. It fit the designated size well. Made in China. It seems to be a good value for the price, and was delivered as promised.

If your garden tractor wheel is a multi faced type wheel and the valve stem hole is on a face not perpendicular to the plane of the wheel, this inner tube is a problem, but can be forced to work with the valve stem lodged at an off angle. Will probably result in earlier failure. I guess I'll find out. This works fine if your wheel valve stem hole is perpendicular to the wheel plane.