Zeelo TL-Smoother kit addon Module for Pattern Elimination Motor Filter Clipping Filter 3D Printer Motor Drivers Controller(Pack of 3pcs)

I printed for about 15 min at normal speed and it caused my extruder motor to start clicking. I ordered 2 packs so total of 6 units but only received 5. So far X, Y, and Z all seem to be fine but the extruder started clicking and did not have any power for whatever reason. I checked the temp and surprisingly X and Y were much hotter than the extruder so not sure whats up with that. As of now, I cannot say that these made any positive difference just yet because i havent made any calibration tests. If i see better quality i will bump up to 3 stars but as of now, they are not good. Also no instructions so not sure which direction to plug them in and also not sure on wire pinout since there is no support for these. I am running MKS GEN L with A4988 drivers if that is helpful.

Arived early. All three work great. Had no issues installing them. Would buy again.

Motherboard stopped working, seems like I will need to buy a new one. After installing this product the machine was rendered useless

I believe it made a difference in reducing salmon skin on my ender 3 prints. Certainly easy to install and not expensive to try!

these worked for a couple weeks then 2 of the 3 died.

all is ok work wellmaybe if your printer has a good quality maybe you dont need itbut with ender 3 or anet a8 work well

I had heard that some Ender 3 models did not need this upgrade. I just got the Pro and decided it would not hurt to install while I was doing the initial assembly. My prints are coming out astoundingly good!

I got this with a few other things but this pack only contained 2 or what should be 3. I sent a message about it and was ignored.